©2015 Wagan Corporation. All Rights Reserved.
Wagan Tech and
wagan.com
are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
11
b. Attach the chuck of the air hose to the tire’s valve stem.
c. Push the chuck lever down to secure the chuck to the valve stem.
• To inflate a sports equipment, air mattress, rafts, or other plastic inflatables:
a. Insert the proper valve stem adapter into stem connector as far as possible.
b. Push the chuck lever down to secure the adapter.
c. Remove the valve cap from your inflatable object if there is one.
d. Insert the other end of the valve stem adapter into inflatable’s air valve opening
as far as possible.
6. Set the Air Compressor Switch on to the “I” position to start inflation.
7. Monitor the pressure gauge while inflating the tire.
8. When recommended tire pressure has been reached, turn off the air compressor.
9. Disconnect the hose and replace valve cap.
10. Return the hose back to its compartment for storage.
11. Recharge the Power Dome as soon as it is convenient.
POWER INVERTER
The Power Dome
®
NX can run most AC appliances or a combination of appliances up to 200
watts. Operating time is dependant on the AC load (required wattage) and the current charge/
condition of the Power Dome’s internal battery. Reduced AC loads and/or having a full charge on
the internal battery will result in longer operating time. Ordinary overloads will cause the inverter
to automatically shut down. Reduce the load and restart the inverter.
There is a user-replaceable automotive-type fuse protecting the inverter from an unlikely excessive
power draw or short circuit. REPLACE ONLY WITH THE SAME TYPE AND RATING FUSE. To
replace the fuse, simply pull it out with a pair of needle nose pliers and insert the new fuse.
Caution
Some rechargeable devices are equipped with a separate AC charger. These devices are
likely to operate properly with the inverter in this unit. Rechargeable devices that have built-in
chargers (see your device’s user manual) may not operate properly with this unit because the
inverter is modified sine wave.
Some motorized devices may operate at excessively elevated temperature when used with this
inverter. During first use with this inverter, check for excessive motor temperature. Abnormally
elevated temperature of the device is an indication that they should not be used together.
Operation
1. Check the required current draw of the appliance/device to be powered and make sure it
does not exceed the Power Dome’s maximum wattage.
2. Prior to plugging in your device, turn your power tool or appliance off. Mobile devices are
fine to keep on, but operating them during the charging process will prolong charging time.
3. Open the AC outlet dust cover.
