background image

Power Dome 400W

10

USER’S MANUAL - Please read before using this equipment.

11

SPECIFICATIONS

  Sealed Lead Acid Battery  - Rechargeable 

12-Volt, 18 Amp Hour

  Work Light with On/Off Switch 

5x LED’s

  Compressor 

   

260 PSI Analog Gauge

  Inverter Output – Modified Sine Wave - Two AC outlets 

115 Volts AC  60Hz

  Maximum Inverter Output Power 

Peak Power

  400 Watts – 1000 Watts peak   

For a max of 0.3 sec

  12V Accessory Outlet 

   

12-volt 11 Amps max

  Max AC Charging Time from discharge 

34 hours

  Max DC Charging Time (engine operating) 

14 hours

  JumpStart Cables and Clamps  

6 Gauge, heavy duty clamps.

   

   

42 in length.

  Dimensions (LxWxH) 

   

10-3/4 x 8.5 x 12-5/8 in.)

   

   

(27.3 x 21.6 x 32.1 cm)

  Weight 

   

17 lbs 13.5 oz  (8.1 kg)

TROUBLESHOOTING GUIDE - INVERTER

  Trouble 

Cause 

Remedy

  Lack of power output 

Power Dome battery voltage below 

Recharge the Power Dome immediately.

   

10 volts.

 
   

Excessive current drawn by 

Reduce load to maximum of 400 watts.

   

appliance being operated.

   

   

1.  Turn OFF the device and inverter. 

   

   

2.  Disconnect device. 

   

   

3.  Turn the inverter ON and leave  

   

   

  running for a minimum of 2 minutes. 

   

   

4.  Turn OFF inverter, quickly plug in  

   

   

  device to inverter making sure device  

   

   

  is OFF prior to connection. 

   

   

5.  Turn ON the inverter and the device.

   

Inverter fuse blown. 

Check and replace if necessary. Be sure  

   

   

any replacement fuse is the same type 

   

   

and rating.

  Inverter Power Indicator 

Excessive voltage drop. 

Check Power Dome and recharge

  is not lit. 

   

if voltage drops below 10 volts.

   

Inverter is overloaded. 

Reduce load to maximum of 400 watts.

  Television/Power Tool 

High surge wattage requirement 

Toggle the On/Off switch in quick

  will not start 

to start-up. 

succession a total of five times. If the  

   

   

device does not start the device is not  

   

   

going to work with this type of inverter.

  Television Interference 

Picture breaking up (snow). 

Place the Power Dome as far as possible  

   

   

from TV, the antenna and the coaxial  

   

   

cable.

   

   

   

   

   

TV station may be out or range.

  Static/Noise interference  Sound system has weak alternating 

Do not use inverter with low quality

  in audio system 

current shielding. 

audio AC filtering system.

   

   

Replace audio system with high quality  

   

   

noise filtering.

Summary of Contents for Power Dome








Reviews: