Solar e Power
™
Case 800 by Wagan Tech
®
18
EN
G
LIS
H
The solar panels should be periodically cleaned during extended use and before storing. Check
your panels weekly or following a storm to make sure no damage has occurred.
• Check for dirt buildup.
• Using a soft brush, remove dust or droppings from the panels.
• Wipe surface with a soft damp cloth.
• Dry the panels with a soft cloth. Solar panels are more efficient when they are clean.
• Check wiring or cables that are attached to the solar panels. Wire or cables may become
loose from turbulent weather conditions.
• Store panels when not in use.
TROUBLESHOOTING GUIDE
Problem
Possible Cause
Solution
No AC output, Green LED
is not lit, Voltmeter reads
below 10 volts
Battery voltage too low
Reduce AC load and charge the Solar e
Power Case battery
Excessive AC load
No AC output, no displays
lit
Inverter Switch is OFF
Turn ON Switch
No AC output, 12 volt
outlet operates, USB ports
operate. Inverter Switch
is ON
Inverter is not working
Call Wagan Tech Support
12 volt DC outlet switches
on and off
DC Outlet is overloaded
Reduce DC load.
Television interference
Picture breaking up (static)
Place the Solar e Power Case as far as
possible from the TV, the antenna and the
coaxial cable
TV station may be out of range
Static/noise interference in
audio system
Sound system has weak
alternating current shielding
Do not use Inverter with low quality audio
AC filtering system
Replace audio system with high quality
noise filtering
Run time is less than
expected
Solar e Power Case is not fully
charged
Charge using the AC Charging Adapter.
Product power consumption is
higher than expected
Check the power or “wattage” rating
and compare with the tables in Battery
Operating Times section of this manual
Charging light is OFF
when AC Charging
Adapter is connected
No AC power at wall socket
Ensure power is available at the wall socket
DC Charging Adapter
does not work
Blown fuse
Check for and replace blown fuse.
