2 3
Paper Loading
If the paper roll needs replacing open the lid and remove the remaining paper
using the feed switch. Do not pull paper out of the rear of the mechanism. Reel
off a few inches from the new paper roll and check that the end is square. Seat
the new roll in the paper well with the paper emerging from the bottom of the
roll.
Make sure the printer is on and offer the paper into
the back of the mechanism while pressing the feed
switch. Keep the feed switch depressed until
enough paper is fed out of the mechanism to pass
through the exit slot in the lid. Feed the page,
through this slot and close the lid
Ribbon Change
The ribbon cassette will clip off on one side
and can be easily removed. After checking
that the ribbon is taut, clip it into position
making sure that the paper still feeds
between the ribbon and the cassette body
correctly. Wind the knob to take up any
slack in the ribbon. Close the lid ensuring
that the paper passes through its exit slot.
Paper Feed
For a single line paper feed press and
release, the feed switch. For continuous line
feed keep the switch depressed
Default Settings
The printer is supplied with the following default settings:
Data bits
8
Parity
None
Baud Rate
9600
Character Set USA
Print Mode
Text
Auto-Off
5 minutes
Emulation
560
TURN WHEEL
IN DIRECTION
SHOWN TO
WIND RIBBON
EJECT
PUSH THIS
EDGE TO
EJECT CASSETTE
1
POWER
LED
SET
UP
FEED
ON
