6. The objects being sprayed must be earthed.
7. Before each use, check all hoses for cuts, leaks,
abrasion or bulging of cover. Check for damage or
movement of couplings. Immediately replace the
hose if any of these conditions exist. Never repair
a paint hose. Replace it with another grounded
high-pressure hose.
8. Pulling the trigger causes a recoil force to the
hand that is holding the spray gun.
The recoil force of the spray gun is particularly
powerful when the tip has been removed and a high
pressure has been set on the airless high-pressure
pump. Therefore, when cleaning without tip set the
pressure control valve to the lowest pressure.
9. Use only manufacturer authorized parts. User
assumes all risks and liabilities when using parts
that do not meet the minimum specifications and
safety devices of the spray gun manufacturer.
Important information about product liability
In accordance with an EC Regulation which came into
force on 01.01.90, a manufacturer may only be held
liable for his product if all of the components are
manufactured or approved by him, and if the equipment
has been assembled properly and used for the purpose
for which it was intended.
The manufacturer’s liability may be rendered partially or
completely invalid if the unit is used with spare parts or
accessories from other manufacturers; in extreme
cases, the competent authorities (trade association or
trade supervisory body) may ban the use of the whole
equipment.
If you use only original Wagner spare parts and
accessories, you can be sure that all safety
requirements are fulfilled.
Specifications
Maximum operating pressure .........27 MPa (3900 PSI)
Material inlet thread size .................M16 x 1.5
NPSM 1/4
Diffuser thread size .........................11/16 - 16 UN-2A
7/8 - 14 UNF-2A
Wetted parts material ......................High-grade stainless
steel, urethane,
polyethylene, nylon,
hard metal
Operating temperature range..........5ºC to 40ºC
(40ºF to 104ºF)
Maximum material temperature ......43ºC (109ºF)
Maximum sound output...................81 dB(A)*
Weight .............................................590 g (1.3 lbs.)
*Measurement location: 0.5 m away from the coating
surface, 0.5 m behind the spray gun, spray pressure 12
MPa, tip size 0.021
© 2005 Wagner. All rights reserved.
3
R
GB
