26
ProSpray 3.23
GB
Description of unit
Starting operation
3.5
Technical data
Voltage:
220-240 Volt , 50/60 Hz
Max. current consumption:
6.0 A
Power cord:
3 x 1.5 mm
2
– 6 m
Acceptance capacity:
1035 Watt
Max. operating pressure:
221 bar (22.1 MPa)
Volume flow at 12 MPa
(120 bar) with water:
2.3 l/min
Max tip size:
0.024 inch – 0.61 mm
Max. temperature of the
coating material:
43°C
Max viscosity:
20.000 mPa·s
Weight:
17.7 kg
Special high-pressure hose:
DN 6 mm, 15 m, connection
thread M 16 x 1.5
Dimensions (L X W X H):
436 x 369 x 416 mm
Max sound pressure level:
80 dB (A) *
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.
3.6 Transportation in vehicle
Secure the unit with a suitable fastening.
4.
Starting operation
4.1
High-pressure hose, spray gun and
separating oil
1. Screw the pressure gauge (1) to the coating material
outlet (Fig. 2, Item 2).
2. Screw the high-pressure hose (3) to the coating material
outlet on the pressure gauge (Fig. 2, Item 4).
3. Screw the spray gun (5) with the selected tip onto the
high-pressure hose.
4. Tighten the union nuts at the high-pressure hoses firmly
so that coating material does not leak.
5
1
4
2
3
5. Remove the oil cup cap with a straight-slot screwdriver.
6. Fill the oil cup with EasyGlide (Fig. 3) until the oil gauge
(6) is showing that it is full.
Attention
EasyGlide prevents increased wear and tear to
the packings.
7. Replace oil cup cap.
8. Press oil button 2-5 times to prime the oiler. Press once
for every eight hours of usage to lubricate the fluid section.
9. Fully depress the pusher stem to make sure the inlet ball
is free.
Summary of Contents for 0558001 ProSpray 3.23
Page 91: ...ProSpray 3 23 89...
