48
OPERATING MANUAL
VERSION 05/2017
ORDER NUMBER DOC 2357061
6.6
COMMISSIONING
WARNING
Gas mixtures can explode if there is an incompletely filled device!
Danger to life from flying parts.
Ensure that the device is always completely filled with flushing agent or working
medium.
Do not spray the device empty after cleaning.
WARNING
High-pressure spray jet!
Danger to life from injecting paint or solvent.
Never reach into the spray jet.
Never point the spray gun at people.
Consult a doctor immediately in the event of skin injuries caused by paint or solvent.
Inform the doctor about the paint or solvent used.
Never seal defective high-pressure parts; instead relieve the pressure from them and
replace them immediately.
Wear the appropriate protective clothing, gloves, eyewear, and respirator
NOTICE
Fluctuating supply pressures!
Poor coating result.
The supply pressure of component B should be adjusted to a higher value (approx. 5-10%)
than that of component A.
The supplying pressure should be constant.
Electrostatic gun
Electrostatic guns must be used
without
electrostatics during commissioning. First
commission the electrostatic system after all steps are carried out up to Chapter
6.6.1 PRE-CLEANING
The devices are tested at the factory using emulsified oil, plain oil or solvent, according to
the kind of fluid being pumped.
Before commissioning the pump with a product, it is recommended to flush both
circuits and supply pumps with an appropriate flushing agent.
WARNING
Incompatibility of flushing agent and working medium!
Risk of explosion and danger of poisoning by toxic gases.
Examine the compatibility of the flushing agents and working medium on the basis
of the safety data sheets.
