21
VERSION 01/2018
ORDER NUMBER DOC 394821
6.4.3 AIR SUPPLY LINES
Ensure that only dry, clean atomizing air is used in the spray gun! Dirt and moisture in the
atomizing air worsens the spraying quality and spray pattern.
WARNING
Hose connections!
Risk of injury and damage to the device.
Do not mix up hose connections of product hose and air hose.
6.4.4 PRODUCT SUPPLY LINES
NOTICE
Impurities in the spraying system!
Spray gun blockage, products harden in the spraying system.
Flush the spray gun and paint supply with a suitable flushing agent.
DANGER
Bursting hose, bursting threaded joints!
Danger to life from injection of product.
Ensure that the hose material is chemically resistant to the sprayed products.
Ensure that the spray gun, fittings and product hose between the device and the
spray gun are suitable for the pressure generated in the device.
Ensure that the following information can be seen on the high-pressure hose:
- manufacturer,
- permissible operating pressure,
- date of manufacture.
6.5
GROUNDING
WARNING
Heavy paint mist if grounding is insufficient!
Danger of poisoning.
Insufficient paint application quality.
Ground all device components.
Ground the work pieces to be coated.
A conductive connection (potential equalization cable) must be established between
original tank and the equipment.
6.6
SAFETY CHECKS
Carry out safety checks in accordance with Chapter
.
6.7
LACQUER PREPARATIONS
The viscosity of the lacquer is of great importance. The best spraying results are obtained
with values between 80 and 260 millipascals (mPas) × sec.
Please also read the technical data sheet of the lacquer for optimal processing, viscosity
adjustment and intermixing of the product.
Summary of Contents for AirCoat GM 4100 AC
