20
GM 4600AC
B_02261
x
OPERATING MANUAL
EDITION 05/2011
Part No. DOC394861
5.3.2
PREPARATION FOR STARTING UP
1. Secure the spray gun.
2. Connect material hose to the spray gun and material supply system.
3. Connect air hose to spray gun and to oil-free, dry air supply with regulator.
4. Insert suitable gun fi lter
5. Place the nozzle into the nozzle seal. Fit the air cap over the nozzle, ensuring that the
location fl ats (X) are in line. Fit the union nut with nozzle guard and tighten by hand.
6. Visually check the permissible pressures for all the system components.
7. Make sure that the unit and all other conductive parts within the work area are
earthed.
8. Set material pressure 100 bar; 10 MPa; 1450 psi and use a suitable medium (solvent or
water) to check that connections do not leak.
Note:
Pull the trigger and then release, checking that the gun closes cleany.
9. Relieve spray gun and unit pressure and secure the spray gun.
Summary of Contents for AirCoat GM 4600AC-H
Page 2: ......
Page 45: ...45 GM 4600AC 45 GM 4600AC OPERATING MANUAL EDITION 05 2011 Part No DOC394861...
Page 47: ......