40
R1
R3
R2
B_03182
2
4
3
OPERATING MANUAL
EDITION 02/2016
ORDER NUMBER DOC 2366600
5.6.3.2
FUNCTIONING OF THE SPRAY GUN
Display (2)
= Recipe values changed temporarily:
If the operating key (4) is pressed for 2 seconds, the saved recipe
values for the previously selected recipes numbers will be
reloaded from the memory.
When the spray gun is connected to the control unit and the
control unit is switched on, the pre-defi ned recipe (R1, R2 or R3)
is shown on the gun display (2) as follows.
Recipe 1
Recipe 2
Recipe 3
Recipe change R1 R2 R3 R1
Press the operating button (4) and hold the button pressed for at
least 2 seconds to go forward 1 recipe.
During spraying mode (trigger lever pressed), the status is shown in the display (2) by LEDs.
LED display
Description
LEDs 1 - 3 light up green.
The spray gun is working in an optimal
high-voltage spray current range.
One or both right-hand LEDs illuminate in
orange.
Spray current too high.
Possible causes:
(Warning display: You can continue
working without any limitations.)
- Spray gun too close to the work piece
- Contamination of the spray gun
5.6.3.1
SECURING THE SPRAY GUN AGAINST ACTUATION
Secure the spray gun against actuation:
Use the trigger lock (11) to engage the trigger (12)
.
Note
: To secure the entire system, pressure must be relieved as described in Chapter 7.3.4.
Summary of Contents for AquaCoat 5010
Page 2: ......
Page 72: ...72 OPERATING MANUAL EDITION 02 2016 ORDER NUMBER DOC 2366600...
Page 159: ......
