ProSpray 39 Select
45
GB
Remedy in case of faults
Digital Electronic Spray Control (DESC) Error
Messages
The following error message screens appear whenever the Digital
Electronic Spray Control (DESC) detects a problem with the sprayer.
Once a problem occurs and the error message appears, the sprayer
will shut down.
Before proceeding, relieve any pressure remaining in
the system (valve position PRIME
). Additionally,
follow all other warnings to reduce the risk of an
injection injury, injury from moving parts or electric
shock. Always unplug the sprayer before servicing!
Check Transducer Screen
CHECK
TRANSDUCER
The Check Transducer screen appears
when the transducer has become
disconnected or is defective. Take the sprayer to a Wagner
authorized service center for repair.
Check Potentiometer Screen
CHECK
POTENTIOMETER
The Check Potentiometer screen
appears when the potentiometer has
become disconnected or is defective. Take the sprayer to a Wagner
authorized service center for repair.
Check Motor Screen
CHECK
MOTOR
Indicates the motor is shut down due to
connection problems between the motor
and controller. Take the sprayer to a
Wagner authorized service center for repair.
Low Voltage Screen
LOW
VOLTAGE
The Low Voltage screen appears when the
sprayer shuts down because of low input
voltage. Check the power supply and correct the problem. Restart
the sprayer.
High Motor Temperature Screen
HIGH MOTOR
TEMPERATURE
The High Motor Temperature screen
appears when the temperature of the
motor has risen too high. Take the sprayer to a Wagner authorized
service center for repair.
High Mechanical Load
HIGH MECHANICAL
LOAD
The High Mechanical Load screen appears
when the sprayer shuts down because of
high current or when the sprayer goes into current fold back mode.
Take the sprayer to a Wagner authorized service center for repair.
High Control Temperature Screen
HIGH CONTROL
TEMPERATURE
Indicates the DESC is shut down due to
excessive heat. Take the sprayer to a
Wagner authorized service center for repair.
Bad Hall Cycle Power Screen
BAD HALL CYCLE
POWER
Indicates the motor or motor hall affect
sensors are defective. Take the sprayer
to a Wagner authorized service center for
repair.
Summary of Contents for Brillux PROSPRAY 39 SELECT
Page 102: ...100 ProSpray 39 Special...
