2 6
Control Pro 350 Extra Cart
GB
Further information about the WAGNER range of products for renovating is available under www.wagner-group.com
Technical Data
Pump type
Piston pump
Power source
230 V
~
50 Hz/ 240 V
~
50 Hz
Power consumption
600 W
Fusing
Only connect to sockets protected with an FI fuse (16 A)
Protection class
I
Max. spray pressure
11 MPa (110 bar)
Max. delivery rate
1.5 l/min
Sound pressure level
*
83 dB (A) Uncertainty K= 3 db
Sound pressure output
*
97 dB (A) Uncertainty K= 3 db
Oscillation level *
< 2.5 m/s
2
Uncertainty K= 1.5 m/s
2
Max. temperature of coating substance
40°C
Hose length
15 m
Max. hose length
30 m
Product dimensions
approx. 78 (93.5) x 38.5 x 52 cm
Weight
approx. 13.0 kg
* Measured in accordance with EN 50580:2014
Information about the oscillation level
The speciied oscillation level has been measured according to a standard test procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational strain.
Attention!
The vibration emission value can difer from the speciied value when the electric tool is actually in use, depending on
how the electric tool is being used. It is necessary to specify safety measures to protect the operating personnel. These measures are
based on an estimated shutdown during the actual conditions of use (all parts of the operating cycle are taken into consideration
here, for example periods when the electric tool is switched of, and, when it is switched on but running without any load).
Environmental protection
The device and all accessories and packaging have to be re-used in an environmentally friendly manner. Do
not dispose of the appliance with household waste. Support environmental protection by taking the appliance
to a local collection point or obtain information from a specialist retailer.
Leftover paint and solvents may not be emptied into drains, the sewage system or disposed of as household rubbish. It has
to be disposed of separately as special waste. Please pay special attention to the instructions on the product packaging.
Important Note regarding Product Liability!
Due to an EC ordinance in efect since 01.01.1990, the manufacturer is liable for his product only if all parts originate from or were
approved by the manufacturer and the devices are assembled and operated correctly. The use of other accessories and spare parts
can partially or completely invalidate the liability.
Correction of Malfunctions
Problem
Cause
Remedy
The sprayer does
not start.
•
The sprayer is not plugged in.
•
The sprayer was turned of while still under
pressure.
•
No voltage is coming from the wall plug.
•
The extension cord is damaged or has too low
a capacity.
•
Device overheated
•
There is a problem with the motor.
➞
Plug the sprayer in.
➞
Perform pressure relief procedure and set selector
switch back to SPRAY
➞
Properly test the power supply voltage.
➞
Replace the extension cord.
➞
Switch the device of, turn the selector switch to the
PRIME position (vertical), remove the mains plug and
allow device to cool down for min. 30 minutes. Eliminate
the cause of overheating, e.g. covered ventilation slot.
➞
Please contact Wagner Service
