30
Control Pro 350 Extra Skid
GB
3+1 years guarantee
The guarantee period amounts to 36 months in case of private use. In the case of private use, the guarantee is extended by a further
12 months if the device is registered online within 4 weeks of the purchase at www.wagner-group.com/3plus1. Registration is only
possible if the buyer is in agreement with the data being stored that is entered during registration.
The guarantee period amounts to 12 months in case of commercial use. If the amount of paint processed with the unit exceeds
1,000 litres, this is considered to be commercial use.
We give a works guarantee to the following extent for this unit:
All those parts that prove to be unserviceable or to be considerably impaired in their serviceability within the guarantee period
since the point of handing over to the buyer due to a circumstance lying before this handing over – in particular due to faulty
design, bad building materials or poor execution – are improved or supplied new as we choose without costs.
Guarantee claims cannot be considered:
- for parts that are subject to wear and tear due to use or other natural wear and tear, as well as defects in the product that are a
result of natural wear and tear, or wear and tear due to use. This includes in particular cables, valves, packaging, jets, cylinders,
pistons, means-carrying housing components, filters, pipes, seals, etc. Damage due to wear and tear that is caused in particular
by sanded coating materials, such as dispersions, glazes, quartz foundation.
- in the event of errors in devices that are due to non-compliance with the operating instructions, unsuitable or unprofessional
use, incorrect assembly and/or commissioning by the buyer or by a third party, or utilisation other than is intended, abnormal
ambient conditions, unsuitable coating materials, unsuitable operating conditions, operation with the incorrect mains voltage
supply/frequency, over-operation or defective servicing or care and/or cleaning.
- for errors in the device that have been caused by using accessory parts, additional components or spare parts that are not
original Wagner parts.
- for products to which modifications or additions have been carried out.
- for products where the serial number has been removed or is illegible.
- for products where the serial number has been removed or is illegible
- for products with slight deviations from the target properties, which are negligible with regard to the value and usability of
the device.
The unit is not conceived for use in shift work or for lending or leasing – these uses are excluded from the guarantee.
The replacement of a part does not extend the guarantee period of the unit.
The unit has to be examined immediately after receipt. Obvious faults are to be reported in writing within 14 days after receipt of
the unit in order to avoid loss of the rights arising from faults.
We reserve the right to have the guarantee fulfilled by a contractual company.
Repairs going above and beyond those dealt with in these operating instructions are reserved for our factory. In case of a guarantee
case or repair, please contact the specialist dealer from whom you purchased the unit.
Fulfilling of the guarantee depends on proof being provided by invoice and delivery note or proof of purchase.
If the check shows that the case is not a guarantee case, repairs are carried out at the expense of the buyer.
Claims against Wagner that are based on or caused by the failure or insufficiency of a unit cannot be asserted.
We make it clear that the guarantee declaration does not represent a limitation of the statutory rights or of the rights agreed
contractually through our general terms of business.
The above guarantees apply exclusively to products that have been bought by authorised specialist shops in the EU, CIS, Australia
and are used within the reference country. If the check shows that the case is not a guarantee case, repairs are carried out at the
expense of the buyer. The above regulations manage the legal relationship to us concludingly. Additional claims, in particular
for damages and losses of any type, which occur as a result of the product or its use, are excluded from the product liability act
except with regard to the area of application. Claims for liability for defects to the specialist trader remain unaffected. German law
applies to this guarantee. The contractual language is German. In the event that the meaning of the German and a foreign text of
this guarantee deviate from one another, the meaning of the German text has priority.
CE Declaration of Conformity
We declare under sole responsibility that this product conforms to the following relevant stipulations:
2006/42/EC, 2014/30/EU, 2011/65/EU, 2012/19/EU
Applied harmonised norms:
EN ISO 12100, EN 1953, EN 62841-1, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3, EN 62233
The EU declaration of conformity is enclosed with the product.
If required, it can be re-ordered using order number
2374079
.
