12
ENGLISH
MAINTENANCE
REPLACING THE FILTER
Aenon
Before every use, you should inspect the air filters
in the turbine to see if it is excessively dirty. If it
is dirty, follow these steps to replace it.
Never operate your unit without the air filters.
Dirt could be sucked in and interfere with the
function of the unit.
1.
Lift up on the tabs on the filter housing and remove.
2.
Remove the dirty filter from the turbine and replace with a
new one. The smooth side of the air filter must be placed
toward the turbine.
Secure the cover back onto the turbine.
CHANGING THE SPRAY NEEDLE
i
Refer to the Parts List for ordering information.
Make sure the turbine is unplugged and the air
hose has been removed from the spray gun.
1.
Unscrew the air cap ring (1) and remove the air cap (2), and
spray directional plate (3).
2.
Using the fluid nozzle wrench, remove the fluid nozzle (4).
3.
Carefully unscrew the material volume control knob (7).
Remove the spring (8). Pull back on the trigger and remove
the needle (9).
Reassemble with the new parts. Start by replacing the
new fluid nozzle (4) into the spray gun and tighten with the
wrench.
Slide the new needle (9) back into the rear of the spray gun
and make sure the tip sits inside the fluid nozzle opening at
the front of the gun. Replace the spring (8) and material
volume control knob (7) and tighten the knob by hand.
Replace the directional plate (3), the air cap (2) and the air
cap ring (1).
1
2
1
2
1
3
2
1
2
4
3
7
8
9
