Operating manual Universal Control Unit for Powder Spray Guns EPG-SPRINT XE
2 Using in Accordance with the Instructions
Order number 2354913 | Edition 10/2022
9
2 USING IN ACCORDANCE WITH THE INSTRUCTIONS
2.1 DEVICE TYPE
Universal control unit for controlling electrostatic manual and automatic spray guns
2.2 TYPE OF USE
The EPG-SPRINT XE control unit is intended for controlling electrostatic manual and
automatic powder spray guns of types A-P (2 mJ) according to DIN EN 50177.
The device may only be operated under the following conditions:
4
Use the device only to work with the materials recommended by WAGNER.
4
Only operate the device as a whole.
4
Do not deactivate safety fixtures.
4
Use only WAGNER original spare parts and accessories.
4
The operating personnel must be trained on the basis of this operating manual.
4
Follow the instructions in the operating manual.
2.3 FOR USE IN POTENTIALLY EXPLOSIVE AREAS
The EPG-SPRINT XE control unit is intended for use with powder spray guns of types A-P up
to 2 mJ in accordance with the type examination PTB 12 ATEX 5001.
The EPG-SPRINT XE control unit may be used in the dust explosion zone (zone 22) under the
following conditions:
– Control unit correctly fitted in rack.
– Rack correctly and securely sealed on rear with corresponding cover.
– All connections not needed (mains output terminal, remote control) are sealed with dust
protection caps.
2.4 PROCESSIBLE WORKING MATERIALS
– Types of powder which can be charged electrostatically
– Metallic powder
Info
Contact your local WAGNER dealer and the lacquer manufacturer if you encounter
application problems.
2.5 MISUSE
Misuse can lead to physical injury and/or property damage! Special attention must be paid
that:
4
No liquid coating products, e.g. solvents or water-based lacquers, are processed.
4
No food, medicine or cosmetics are processed.
