MATeRiAl PRePARATioN
1
2
3
6
eN
To PRePARe The MATeRiAl
1.
Stir the spraying material thoroughly.
2.
unscrew the cup from the nozzle.
3.
After the material has been properly thinned* and strained,
fill the container to desired level.
*ThiNNiNG The MATeRiAl
For certain spraying situations or desired finishes, thinning the
material may be desired. It is not necessary for most materials
when used with the iSpray nozzle. For use with the detail Finish
nozzle thinning may be needed to acheive a finer finish. make
sure you adjust the X-boost™ and material flow settings for your
specific material needs.
If thinning is necessary, use the proper solvent as specified by
the material manufacturer. Never exceed the thinning advice
given by the coating manufacturer.
do not thin with materials that have a flashpoint
below 100°F (38°C).
i
material to be sprayed may need to be strained to remove any impurities in the paint which may enter and clog the
system. Impurities in the paint will give poor performance and a poor finish.
only thin the material if absolutely necessary to improve spray performance. optimal spray performance should be
acheived simply by adjusting the various controls on the unit.
