EN
13
SPRAYER CONTROLS
ADJUST SPRAY PATTERN
AIR CAP
AIR CAP EARS
Horizontal pattern
=
=
Use ‘up and down’
spraying motion
Vertical pattern
=
=
Use ‘side to side’
spraying motion
Round pattern*
=
Use ‘up and down’ or
‘side to side’ spraying
motion
Use lower air power /
material flow
For coating smaller
areas, corners and
edges
Adjust the spray pattern by turning the air cap ears. The air cap
position will determine the movement direction of the spray gun.
The positions of the air cap and the corresponding spray pattern
shapes are illustrated below.
Test each pattern and use whichever pattern is suitable for your
application.
NEVER trigger the gun while turning the
adjustment ring. NEVER point the spray gun at
any part of the body.
Attention
When changing the spray pattern, make sure the
black retaining ring is not loosened.
i
*The air cap can be set diagonally on the Detail
Finish nozzle only. To achieve a round pattern with
the iSpray nozzle, see the “Adjust Spray Width”
section.
The spray width lever on the iSpray nozzle determines the width of
the spray pattern.
TIPS:
1.
Start with a narrow fan pattern for painting trim work (1-5” width)
and larger surfaces like doors and walls (>5” width).
2.
Adjust Material & Air Flow settings as shown in chart based on
coating, fan pattern width, and nozzle.
3.
Fine tune the Material and Air Power settings to achieve the best
results for your application.
4.
Use narrow pattern for detailed work, touch up.
5.
Recommended settings for Material and Air Power may change if
the coating is thinned.
ADJUST SPRAY WIDTH (iSPRAY ONLY)
WIDE
NARROW
Wide pattern
For coating large
surfaces
Use higher air power
Use higher material
flow
Narrow pattern
For coating smaller
areas, corners and
edges
Use lower air power
Use lower material
flow