WAGNER FLEXiO 4000, Owner'S Manual

eN

13

CleANUP (CoNTiNUeD)

CleANiNG The Nozzle

1. 

make sure power cord is unplugged.

    remove the air hose from the rear of the spray gun handle.

2. 

iSpray nozzle only - 

  a.  remove the air cap (a) by prying it off the connecting nut 

(inset).  loosen the connecting nut (b).

  b.  remove the parts as shown.  Clean all parts with a cleaning 

brush and the appropriate cleaning solution.

    reassemble all parts when clean.

3. 

Detail Finish nozzle only - 

  a.  unscrew the nut and remove the air cap and nozzle.
    remove the parts as shown(*).  Clean all parts with a cleaning 

brush and the appropriate cleaning solution.

    reassemble all parts when clean(**).

4. 

Clean the air vent (c) on the suction tube with a soft bristled 

cleaning brush.  

5. 

Clean the rear of the nozzle (d) with the appropriate cleaning 

solution.  use a thin layer of petroleum jelly to lubricate the 

o-ring (e).

1

2

(a)

(b)

3

4

(c)

5

(d)

(e)

*

(*)  

the  nozzle  seal  may  become 

stuck inside the detail Finish nozzle 

when the nozzle is removed.  If this 

occurs, make sure to pull it out.  

**

(**)  

It is important that the nozzle 

seal inside the nozzle be re-installed 

properly.  make sure the cup side of 

the seal (the side with the groove) is 

facing  out  towards  the  front  of  the 

nozzle.    Improper  installation  will 

cause  leakage  and  damage  to  the 

turbine. 

Groove