39
GA 2800EA, GA 2805EA
#
$
%
!
"
"?
OPERATING MANUAL
EDITION 12/2008
PART NO. DOC350731
8.6
REPLACING THE PAINT HOSE
1. Unscrew nut (A) using the universal spanner.
2. Pull material hose (B) out of the connection (C).
3. Remove insert (D), clamping ring (E) and nut (A) from material hose.
4. Pull the material hose back through the protective sleeve (F) and remove it.
If the material hose has been ordered per meter, strip the insulation from 75 mm; 3.0 inch
at both ends (see special accessory 9.4)
5. Fit the nut (A) and clamping ring (E) over the material hose (B).
6. Insert the cleaned or new sealing sleeve (D) into the material hose (B).
7. Wet the material hose (B) on the insert length with high voltage oil
Note
The high voltage oil protects against high voltage burn-through (leakage to earth or
atmosphere)
8. Insert material hose (B) into the connection (C) as far as it will go.
9. Pull the union nut (A) over the clamping ring (E) and gently tighten it with the universal
spanner.
Mounting with
insulating oil
7!2.).'
$AMAGEDMATERIALHOSE
2ISKOFINJURYFROMCOATINGMATERIALCOMINGOUT
%LECTRICSHOCKRISK
7HEN REMOVING INSULATION ENSURE THAT THE INNER HOSE IS NOT
DAMAGED
3)()??'"
