32
GA 4000ACIC
B_03054
A
B
C
D
B_03071
X
OPERATING MANUAL
EDITION 06/ 2011
PART NO. DOC2312956
1. Relieve the pressure of gun and unit.
2. Secure gun (Remove the control air hose).
3. Screw off the union nut (A).
4. Remove air cap (B).
5. Pull out the clogged nozzle (C) from the air cap (B), reverse it and replace it into nozzle
seal (D).
6. Refi t air cap (B) on the nozzle (C). Take care that the nozzle fi tted is correctly (see fl at
side X).
7. Fit the union nut (A) over the air cap (B) onto the spray gun and tighten by hand.
8. Switch the material pressure back on.
9. Spraying (Connect control air hose).
10. When the blockage has been fl ushed out secure the spray gun.
11. Relieve the pressure of gun and unit.
12. Secure gun (Remove the control air hose).
13. Screw off the union nut (A).
14. Remove air cap (B) and reverse AirCoat nozzle (C) by hand again. Nozzle and nozzle
seal clean and to nozzle in spraying position the nozzle seal (D) put on.
15. Refi t air cap (B) on the nozzle (C).
Take care that the nozzle fi tted is correctly (see fl at side X).
16. Fit the union nut (A) over the air cap (B) onto the spray gun and tighten by hand.
17. Connect control air. Switch the material pressure and the air pressure back on.
Nozzle in „spray“ position
Nozzle in „cleaning“ position
5.4.5
ELIMINATE NOZZLE CLOGGING