30
8.2.4 REPLACING THE PRODUCT HOSE OR AIR HOSE
1. Flush and clean the spray gun in accordance with Chapter
.
2. Relieve the pressure of the spray gun and device.
3. Secure the spray gun with the trigger locking device.
Product hose
4. Place the size A open-end wrench on the upper part of the product connection and
hold it in place.
5. Unscrew the product hose nut using the size B open-end wrench.
Air hose
4. Place the size D open-end wrench on the upper part of the air connection and hold
it in place.
5. Loosen the air hose's nut with a size C open-end wrench.
Assembly:
6. Screw on the product hose or air hose by hand and tighten with the two open-end
wrenches.
P_02386
B_02385
A
D
C
B
Note:
Do not unscrew the
filter connection.
The filter connection
should be replaced
in accordance with
Chapter 10.8.
Description
Wrench A
Wrench B
Wrench C
Wrench D
GM 4700AC with NPS1/4" filter
19 mm
0.75 inch
19 mm
0.75 inch
17 mm
0.67 inch
17 mm
0.67 inch
VERSION 06/2018
ORDER NUMBER DOC2311730
Summary of Contents for GM 4700AC
Page 1: ...AirCoat Manual Gun for Flat and Round Jet Nozzles Version 06 2018 B_02376...
Page 2: ......
Page 48: ...48...
