50
GM 5000EA
OPERATING MANUAL
EDITION 04/2016
ORDER NUMBER DOC2344499
7.3.4
PRESSURE RELIEF/WORK INTERRUPTION
Process for relieving pressure
1.
Switch off control unit.
2.
Close the compressed air supply.
3.
Relieve pressure according to the operating manual of the product pressure
generator.
4.
Point the spray gun toward the grounded collecting tray.
5.
Pull the trigger of the spray gun until no further pressure is present.
The pressure must always be relieved when:
- The spraying tasks are fi nished.
- The spraying system is maintained.
- Cleaning tasks are carried out on the spraying system.
- The spraying system is moved to another location.
- Something must be checked on the spraying system.
- The nozzle is removed from the gun.
Observe general safety instructions in Chapter 4.
High-pressure spray jet!
Danger to life from injecting paint or solvent.
Never reach into the spray jet.
Never point the spray gun at people.
Consult a doctor immediately in the event of skin injuries caused
by paint or solvent. Inform the doctor about the paint or solvent
used.
Never seal defective high-pressure parts; instead relieve the
pressure from them and replace them.
Wear the appropriate protective clothing, gloves, eyewear and
respiratory protection.
WARNING
