11
PEA-C4-HiCoat
OPERATING MANUAL
VERSION 05/2012
ORDER NUMBER DOC 390829
3.3
SAFETY IDENTIFICATIONS
Plates bearing information for the user have been attached to the work openings of the
powder coating booth.
The plate size corresponds to the standard category Ø 100 mm; 3.94 inches.
The label plates, which must be attached, are shown below:
Explosive atmosphere!
Close to the spray area a warning sign (included in the delivery of the installation) has to be
placed with the following indications:
The equipment may only be operated by trained staff .
Before starting cleaning the spray gun or carrying out any other work in the spray
area, the high-voltage must be shut down in such a way that it cannot be activated
again by actuating the trigger of the spray gun.
Use only metallic containers for cleaning fl uids.
Preferably use solvents with the highest possible fl ash point, higher than the ambient
temperature if possible.
The electrostatic spraying unit must be maintained regularly according to the
manufacturer's instructions. Repairs may only be performed according to the
manufacturer's instructions.
Forbidden for unauthorized
persons!
