Maintenance and cleaning
12
0351709
- PEM-T3
03/2008
4.2
Cleaning the spray gun and replace the wear parts
Caution
Never
place the spray gun or parts of it into any wet cleaning agent!
0402_Pemt3_Verschlaustausch.doc
Caution
While pulling out and replacing the wearing parts make sure that the parts of the
charging body are not damaged.
1
2
4
5
3
Pemt3_0005
•
Pull the deflector cone
1
from the
charging body
5
.
•
Unscrew the outer nut
2
from the gun
housing
3
.
•
Carefully pull out the nozzle body
4
from the gun housing
3
.
•
Carefully pull out the charging body
5
.
•
Check the removed parts for wear.
The
entire
charging body can be
replaced with a
new
one during this
procedure.
It is also possible to dismantle the charging body and merely replace the parts affected by
wear.
14
13
7
6
8
9
10
Pemt3_0006
•
Carefully unscrew the tip
6
from the
threaded bar
7
and dismantle the
charging body.
•
Unscrew the air nozzle
14
from the
deflector cone rod
13
if worn and
replace it with a
new
one.
•
Complete clean residual powder from
all parts.
•
Replace worn parts with new ones.
•
Reassembly of the charging body.
•
Carefully push the charging body back
into gun and reassemble the gun.
Summary of Contents for PEM-T3
Page 24: ...Notes 24 0351709 PEM T3 03 2008...
Page 25: ...Notes 03 2008 0351709 PEM T3 25...
