8
PEM-X1
OPERATING MANUAL
VERSION 09/2012
ORDER NUMBER DOC 2326020
2
CORRECT USE
2.1
DEVICE TYPE
Powder spray guns for manual coating of grounded work pieces
2.2
CORRECT USE
The PEM-X1 manual powder spray gun is designed for the electrostatic coating of work
pieces with organic powders. Any other form of use is considered not intended use.
Wagner disclaims liability for any damage resulting from not intended use.
The spray gun may only be used in spray areas equipped in accordance with EN 50177 or
under equivalent ventilation conditions.
2.3
FOR USE IN POTENTIALLY EXPLOSIVE AREAS
This type A-P electrostatic powder spray gun is suitable for processing industrial powder
paints for coating electrically conductive objects and can be used in potentially explosive
atmospheres (zone 22). (See chapter 3.1 "Explosion Protection Identifi cation").
2.4
SAFETY PARAMETERS
The powder hand gun is only suited to the application of powder paint.
J. Wagner AG forbids any other use!
The powder spray gun may only be operated under the following conditions if:
the operating staff have previously been trained on the basis of this operating manual,
the safety regulations listed in this operating manual are observed,
the operating, maintenance and repair information in this operating manual is
observed,
the statutory requirements and accident prevention regulations standard in the
country of use are observed.
The manual powder spray gun may only be operated if all parameters are set and all
measurements/safety checks are carried out correctly.
