• Check viscosity of the coating material.
• Fill coating material into the receptacle. With mineral
coating materials only fill the receptacle to half full.
Spray lance with automatic control
• Open material tap (3, fig. 16).
• The coating material will be pumped into the mortar
hose.
Spray lance without automatic control
• Open material tap (3, fig. 17).
• Turn on device with remote control switch (1, fig. 17).
• Coating material will be pumped into the mortar hose.
• Pump synthetic resin dispersion or cellulose paste
from the mortar hose into a bucket.
• As soon as coating material starts coming out of the
spray lance – turn off device using remote control and
close material tap on the spray lance.
• Hold spray lance over the receptacle.
• Open material tap (3, fig. 16 and 17) and turn on
device using remote control.
• Set the feed rate regulator (3, fig. 3, page 29) to the
required feed rate.
• Turn off device using remote control and close
material tap (3, fig. 16 and 17).
• Fasten mortar hose using hose holder to the frame
(each connecting hose separately).
Do not kink the mortar hose!
Protect it against damage e.g., resulting
from it being run over or from sharp
objects.
Starting the spraying procedure
• Open air tap (2, fig. 16 and 17) and material tap
(3, fig. 16 and 17) on the spray lance.
Spray lance without automatic control
Turn device on using remote control switch
(1, fig. 17).
End of the spraying procedure
Spray lance with automatic control
• Turn switching sleeve (1, fig. 16) 90
°
clockwise as far
as it will go.
• Wait 3–5 seconds.
• Close material tap (3, fig. 16).
Noncompliance with the above instructions
will result in additional wear of the material
tap.
• Close air tap (2, fig. 16).
Spray lance without
automatic control
• Press remote control switch (1, fig. 17) on mortar
hose.
• Wait 3–5 seconds.
• Close material tap (3, fig. 17).
Noncompliance with the above instructions
will result in additional wear of the material
tap.
• Close air tap (2, fig. 17).
Spray lance with automatic control (fig. 16)
Spray lance without
automatic control (fig. 17)
8 General requirements for application
technology
Spraying technique
Guide the spray lance at a uniform distance of
30 – 60 cm from the object when spraying. If you do not
do this, you will not achieve a regular spray pattern.
36
g
3
2
1
2
1
3
Summary of Contents for Plast Coat 25
Page 1: ...Ow n e r s Ma n u a l...
Page 10: ...Tabelle Teil 1 32 g...
Page 11: ...Tabelle Teil 2 33 g...
