The spray pattern is dependent upon the type of
material, material consistency, tip size, material delivery
rate and air delivery rate.
Examples:
fine texture ––> larger air delivery rate
coarse texture ––> low air delivery rateHigher
material delivery rate –> higher air delivery rate
We recommend that you test the required texture on a
sample surface.
To improve the "feathering effect" in order to allow
easier overlap, choose an appropriate distance between
the spray lance and the object surface.
The spray margin should "feather out" to allow easier
overlapping.
Considerably less spray mist is produced if the spray
lance is always guided at 90
°
parallel to the spray
surface.
Note:
Sharp-edged grains and pigments will increase
wear on the pump, hose, material ball valve and
tip.
9 Fitting accessories
9.1 Compressor
V 400 suction volume 360 l/min
•
Attach compressor holder (item 1, fig. 18) and
secure with star grip (2).
•
Place compressor onto holder. Slide retaining plate
(3) over the compressor base.
•
Secure the compressor with star grips (4).
Compressor
C 350 suction volume 350 l/min
•
Attach compressor holder (item 1, fig. 19) and
secure with star grip (2).
•
Place compressor onto holder, attach retaining
plate (3).
•
Secure the compressor with star grips (4).
9.2 Sack mangle
•
Use sack mangle together with sliding cover
(accessory item 1, fig. 20).
•
Place sliding rails (2) under the sliding cover from the
front.
Turn crank handle and move sack mangle
backwards as far as it go.
•
Adjust the pressure force of the roller (4) with the
star grips (3).
37
g
3
4
2
1
1
2
3
4
Summary of Contents for Plast Coat 25
Page 1: ...Ow n e r s Ma n u a l...
Page 10: ...Tabelle Teil 1 32 g...
Page 11: ...Tabelle Teil 2 33 g...
