Using coating materials in sacks
•
Pull sliding cover back about 15 cm.
•
Place sack on the sliding lid.
•
Cut sack open.
•
Allow the coating material to flow into the receptacle.
•
Move sack mangle forwards over the sack by turning
the crank.
Danger of crushing
Do not place hands under the rollers.
9.3 Container suction system
•
Turn off device at master switch.
•
Pull out mains plug from the socket and ensure
that it cannot be plugged back in unintentionally.
•
Unscrew the hexagon nuts (2) on the receptacle
(1, Fig. 21), remove washers.
•
Remove receptacle.
•
Attach container connection (3) to the base of the recep-
tacle. Mount disks and secure with hexagon nuts (4).
•
Connect suction hose (5) to container connection (3).
Alternatively, connect connecting bridge (6) to the
container connection (3) and connect suction hose
to connecting bridge.
•
Fill suction hose with water and connect to the
container.
•
Turn on mortar spraying machine.
Note:
All connections must be sealed air tight so that a
vacuum can be produced.
Place a small amount of machine lubricant onto the
rubber seals of the connections in order to allow for the
easy opening and closing of the connectors.
10
Placing out of operation and cleaning
Do not spray the motor or control unit of
the mortar spraying machine with water
jet, high-pressure or steam cleaning
equipment. Water could penetrate the
machine and cause a short-circuit.
10.1 Cleaning the mortar hose
•
Pump until receptacle is empty.
When operating using the container suction system,
remove suction hose from the container.
Important: Do not let the mortar spray machine
run dry.
•
Remove texture nozzle from spray lance and clean.
The mortar hose must be without
pressure. If necessary, turn changeover
switch briefly to (backwards).
Note the pressure gauge ––> 0 bar.
Wear protective goggles.
•
Disconnect the mortar hose from the outlet section.
•
Insert cleaning ball in the mortar hose.
Re-connect the mortar hose.
38
g
2
3
4
1
5
1
4
3
6
2
Summary of Contents for Plast Coat 25
Page 1: ...Ow n e r s Ma n u a l...
Page 10: ...Tabelle Teil 1 32 g...
Page 11: ...Tabelle Teil 2 33 g...
