39
•
Fill water into receptacle.
When operating using the container suction system,
immerse suction hose into receptacle with water.
Turn on mortar spraying machine.
•
After a few seconds the cleaning ball will come out
of the spray lance.
•
Repeat cleaning procedure 3–4 times, depending on
the coating material used.
There is a further possibility for cleaning using the
cleaning adapter.
This cleaning adapter can be connected to a water hose
or tap with a claw coupling.
Place cleaning ball in the mortar hose.
Couple mortar hose to the cleaning adapter and rinse
through with water.
10.2
Cleaning device and changing pump jacket
Pump jacket disassembly
• Lubricate pump
Turn changeover switch to (backwards).
Spray pump antiseize or a little dishwashing liquid
into the outlet unit (2, fig. 22) or place a little
dishwashing liquid into the receptacle and pump
through the pump.
• Turn changeover switch to "0".
• Unscrew star grips (1, fig. 22).
• Remove outlet unit (2) towards the front.
• Set feed rate to "3".
• Turn changeover switch to (forwards).
Danger of crushing
• Pump jacket (3) will disconnect from pump screw.
• Set changeover switch to "0".
• Clean receptacle and receptacle lower section with a
water jet.
When operating using the container suction
system, turn off device using master switch.
Remove the mains plug from the socket and
ensure that it cannot be replaced
unintentionally.
• Unscrew and remove container connection from the
receptacle lower section.
• Clean receptacle lower section, container connection
and suction hose with a water jet and, if necessary,
using a suitable brush.
• Clean pump screw and pump jacket thoroughly with
water.
• Clean outlet unit (2) inside using a bottle brush.
• Keep threads for the star grips clean and grease.
Pump jacket assembly
Important:
Spray pump screw and pump jacket with
pump antiseize or wet with dishwashing
liquid.
• Turn changeover switch to (backwards).
Danger of crushing
• Place pump jacket (3) onto pump screw.
• Ensure that the ledge of the pump jacket (3) is
properly slid into the rectangular recess of the pump
trigger (4).
• Pump jacket pulls itself onto the pump screw.
• Set changeover switch to "0".
• Assemble outlet unit.
10.3 Cleaning spray lance
• Clean texture nozzle.
• Clean air holes in the texture nozzle with a cleaning
needle.
• Clean the inside of the spray lance with a bottle
brush
g
3
2
1
4
Summary of Contents for Plast Coat 25
Page 1: ...Ow n e r s Ma n u a l...
Page 10: ...Tabelle Teil 1 32 g...
Page 11: ...Tabelle Teil 2 33 g...
