2
Introduction to working
with the mortar spraying machines
PlastCoat 25 and 35
The mortar spraying machines can be combined with
continuous flow, gravitation compulsory or pan mixers
for the processing of mineral coating materials.
The container suction system (accessory) can be used
to suck directly from a container.
2.1 Operation of the mortar spraying machines
PlastCoat 25 and 35
The coating materials are supplied to the machine by
means of the receptacle. The spiral conveyor feeds the
coating material into an eccentric screw pump. This pump
generates the pressure required for the transport through
the mortar hose. The compressed air necessary for the
atomizing of the material is fed into the spray lance.
The mortar spraying machine can be switched on and
off using the electrical remote control.
The continuously adjustable feed rate of the coating
material can be used to create a soft, even spraying
pattern.
2.2 What materials can be sprayed?
• Heat insulating composite system adhesive
(mineral and synthetic resin systems)
• Synthetic resin plasters up to grain size of 5 mm
• Silicate plasters up to grain size 5
• Silicate resin plasters up to grain size 5
• Mineral final coat plaster up to grain size 5
• Light plaster systems up to grain size 5
• Scraped rendering up to grain size 5
• Insulation plaster
• Renovating plaster
• Foam mortar coating
• Quartz plastic
• Roof coatings
• Flameproof coatings
• Mineral sealing slurries
• Bitumen emulsions
• Reinforcing filler
• Liquid wood chip
• Frame sealing mortar
• Synthetic resin rendering base
• Primer
• Filling paints, incl. fiber containing
• Elastic coatings
• Acoustic plaster, synthetic resin bonded
• Filler, synthetic resin bonded
• Concrete trowel
All coating materials should be suitable for applying
using machines. See product data sheet for the coating
material to be used.
Only use other materials after prior consultation with the
manufacturer or WAGNER application technology dept.
3 Technical data
PlastCoat 25
PlastCoat 35
Voltage:
230 V ~, 50 Hz
400 V, 50 Hz, V3 ~
Fuse protection:
16 A slow-blow
Device mains cable
6 m long:
3 x 2.5 mm
2
5 x 1.5 mm
2
Motor output P
1
:
2.2 kW
3.6 kW
Max. feed rate (water)
Pump yellow:
10 l/min
15 l/min
Pump brown:
15 l/min
20 l/min
Pump green:
20 l/min
25 l/min
Max. operating pressure:
40 bar
Max. grain size:
K 5 mm
Measurements L x W x H:
1200 x 520 x 660 mm
Receptacle capacity:
60 l
Weight:
85 kg
87 kg
Tire pressure, max.:
2.5 bar
Protective system:
IP 54
Max. sound pressure level:
77 dB (A)*
Atomization air connection:
Rapid action coupling
DN 7 mm
Max. atomization air pressure:
10 bar
Required volume of
compressed air, min:
220 l/min
Texture nozzle:
8 mm (standard)
Mortar hose:
DN 27 mm, 10 m (standard)
* Measuring point: At a distance of 1m to the side of the
unit and at a height of 1.60 m above floor, reverberant
floor.
27
g
Summary of Contents for Plast Coat 25
Page 1: ...Ow n e r s Ma n u a l...
Page 10: ...Tabelle Teil 1 32 g...
Page 11: ...Tabelle Teil 2 33 g...