WAGNER Plast Coat 25, Operating Manual

37

Plast Coat 25 · 35

GB

placIng Into operatIon

Preparing the mortar spraying machine

Only work with the safety grill inserted!

Recommended lubricant for the mortar hose

Water is not a satisfactory lubricant.

Danger of blockages!

Synthetic resin products   –>  synthetic  resin  

                                                          dispersion

PCC systems 

          –> cellulose paste

Spray lance with automatic control

•  Open material tap (3, fig. 15) on the spray lance. The mortar 

spraying machine will switch on.

Spray lance without automatic control

•  Open material tap (3, fig. 16) on the spray lance. Press remote 

control switch (1, fig. 16). The mortar spraying machine will 

switch on.

Spray lance with automatic control

•  When the synthetic resin dispersion or cellulose paste has 

been pumped into the mortar hose – turn off device, turn 

switching sleeve (1, fig. 15) by 90° in a clockwise direction as 

far as it will go.

•  Close material tap (3, fig. 15).

extension cable PlastCoat 25

The cross section of the cable must be min. 

3 x 2.5 mm. Unwind extension cable com-

pletely. Make sure that the couplings and 

plugs are in complete working order.

Arrange  the  mains  cable  so  that  there  is  no 

danger of it being tripped over.

Protect  against  damage,  e.g.,  caused  by  it 

being run over. 

•  Before connecting to the mains make sure that the mains 

voltage  is  in  accordance  with  the  details  on  the  rating 

plate. 

•  Only connect to the mains supply using a special distribut

-

ing point, e.g. using a site distribution system with fault cur-

rent protection with INF ≤ 30 mA.

•  Connect mortar spraying machine to the mains supply.

•  Fill 2–3 l synthetic resin dispersion or cellulose paste into the 

receptacle.

• 

Caution:

 set changeover switch (4, fig. 14) to „0“ before turn-

ing on the master switch (1, fig. 14).

the pump is switched on, even if the feed rate 

regulator is at position „0“.

•  Turn master switch (1, fig. 14) to „1“, the indicator lamp will 

show that the machine is ready for operation.

•  Set feed rate regulator (3) to „5“.

•  Turn changeover switch (4) to „AUTO“ (remote control using 

spray lance).

•  Hold spray lance over an empty bucket.



7

1 6

2

8

3

5

4

extension cable PlastCoat 35

The cross section of the cable must be min. 

5 x 2.5 mm. Unwind extension cable com-

pletely. Make sure that the couplings and 

plugs are in complete working order.

2

3

4

1

