25
GM 1-350/530
B_5047
A
B
C
D
C
F
E
OPERATING MANUAL
VERSION 02/2015
ORDER NUMBER DOC2349369
1. Flush and clean the spray gun as described in Chapter 8.1.3.
2. Relieve the pressure on the spray gun and product pressure generator in accordance
with Chapter 7.3.2.
3. Secure the spray gun with the locking device.
4. Use the guard bracket (B) with integrated hex tool to loosen and unscrew the fi lter
housing (A).
5. Remove the fi lter insert (C) from the fi lter housing (A).
6. Thoroughly clean the fi lter housing and gun handle with cleaning agent.
Assembly:
7. Insert a new fi lter insert (C) with opening downwards into the fi lter housing (A).
Check the seal (F) to make sure it is in good condition and positioned correctly.
Notice: if the seal (F) becomes damaged, it must also be replaced (order no. 364340).
8. Use the guard bracket to screw in and tighten the fi lter housing (A).
Note: If the fi lter insert (C) gets stuck in the fi lter socket (E), pull off the gun handle (D)
and carefully remove the fi lter insert (C).
8.5
CHANGING OR CLEANING FILTER INSERT
Disassembly
Installation
position
seal (F)
