38
TempSpray-H326 / -H226 / -H126
GB
4
STARTUP
4.1
TEMPSPRAY-H326 AND TEMPSPRAY-H226
1. Place hose drum close to the Airless-unit.
2. Release hose whip (1) from frame and roll up the high-
pressure hose. Also release the lock-advice (2) and lock it
again after rolling the hose up.
3. Release connecting hose and connect it to the hose
adapter of the airless-unit.
4. Mount spray gun (4) to the hose whip.
5. Tighten all coupling nuts strongly, in order that no coating
material can leak.
6. Mount the nozzle holder with the chosen nozzle on the
spray gun, position it and tighten it well (See manual of
the spray gun/ nozzle holder).
For safety reasons never use the heating-
hose without the steal-armoured hose whip,
if working with a spray gun.
Counter with a wrench, if you unscrew the
high-pressure hose from the hose connector.
4.1.1
CONNECTION TO THE MAINS NETWORK
Connection must always be carried out via
an appropriately grounded safety outlet with
residual-current-operated circuit-breaker.
4.1.2
CLEANING PRESERVING AGENT WHEN
STARTING-UP OF OPERATION INITIALLY
Rinse the heating hose with a suitable cleaning agent (recom-
mendation: water) at a low pressure setting. Therefore use a
spray gun without nozzle and spray into an open box.
Before connecting the unit to the mains supply, ensure that
the line voltage matches that specified on the unit’s rating
plate.
STARTUP
3
2
1
4
