Installation
TITANUS
SUPER·SENS
®
5
– 8
Data:
02/09
TSS_05_A-en-e
Fig. 5.4: Installation of the reset board in
TITANUS
®
Installation in TITANUS
®
In order to install the reset board in TITANUS
®
the following steps are to
be followed (refer to
7H
Fig. 5.4):
Loosen the four screws on the housing lid of TITANUS
®
and lift it
up carefully.
Pull the cable of the display board off the base board. Now re-
move the housing lid.
Place the calculated end of line resistor
0F
1
R
ER
into the connection
terminal X1.
Attach the reset board by means of 2 plastic screws (KB 30x8).
Use the plastic mounting posts of the TITANUS
®
-housing.
Fix the cable of the display board at the base board and close the
housing lid.
Attach the lid by means of the four screws.
The electrical connector (X2) is described in section 5.6.4.
1
end of line resistor not included, power 1/4W