TITANUS
SUPER·SENS
®
Installation
TSS_05_B-en-e Data:
02/09
5
– 29
5.10.2 Remote display housing design
Application of the front film sheet
Fig. 5.23: Application of the front film sheet to the remote display
The lid of the remote display can be turned by 180°. This allows the cable
entries to be placed either on the top or on the bottom (refer to
4H
Fig. 5.23).
Wall Mounting
The remote display in the housing is directly screwed to a wall with its
bottom casing
.
Mounting Material
Remote Display Unit
cylinder or flat-head screws
– thread diameter: max. 4 mm
– head diameter: 5 to 7 mm
Distances of the Holes
The drill hole distances are illustrated in the following figure (all dimen-
sions mm).
Fig. 5.24: Drill hole distances in the housing