Technical Description
TITANUS
SUPER·SENS
®
2
– 14
Data: 02/09
TSS_02_A-en-e
2.2.4 Remote display units
remote display unit
in wall housing
remote display unit
for 19"-subrack
blind plate
for 19"-subrack
Fig. 2.8: Remote display unit for 19“-subracks and wall mounting
TITANUS
®
has connectors for a maximum number of two remote display
units per device. The displays of the remote display unit are the same as
those of the basic device. The remote display units are connected to the
base board of TITANUS
®
.
A remote display unit can be installed in a distance of up to
1000 m
. If
two remote display units are mounted at the same time the total length of
the connection lines must not be longer than
500 m
.
For small distances the power supply is directly guaranteed by the
TITANUS
®
, for long distances it is guaranteed by an external power sup-
ply (refer to chapter 4.8 “Calculation of the Power Supply“).
There are two types of remote display units available (refer to
7H
Fig. 2.8):
Types
z
for the wall mounting in housing
z
for the installation into a 19“-subrack (3 units of height, 21 submultiples
of units)
The housing lid of the wall housing type is turn able by 180°, which
means that the cable entries can be on the top or on the bottom.
Up to 4 remote display units can be mounted in a 19“-subrack. For un-
used modules use the corresponding blind plates.
