24
VERSION 02/2019
ORDER NUMBER DOC 2397374
TOPFINISH GM 1030P
7.3
ADJUSTING THE SPRAY PATTERN
Desired spraying result
B_06976
Rectifying defects in a spray pattern
Spray pattern
Deviation
Required setting
B_06977
Spray pattern is too wide
in the middle
– Set a wider spray shape
B_06978
Spray pattern is too wide
on the ends
– Set a rounder spray shape
B_06979
Spray pattern has very
coarse droplet distribution
– Increase the atomizing air pressure
B_06980
Material application is very
thin in the middle of the
spray pattern
– Reduce the atomizing air pressure
B_06981
The spray pattern is
divided in the middle
–
–
–
Increase the nozzle diameter
Reduce the atomizing air pressure
Increase the product pressure
B_06982
Spray patter is too round
–
–
Reduce product pressure
Increase the atomizing air pressure
Note:
The flow rate can be changed by:
– Changing the product pressure or limiting the needle stroke.
– Use of another nozzle (see Chapter
).
Summary of Contents for TOPFINISH GM 1030P
Page 1: ...B_06965 TOPFINISH GM 1030P Airspray manual gun for flat and round jet nozzles Version 02 2019...
Page 2: ......
Page 26: ......
Page 51: ......