GB
23
W 150
paint into the original paint container.
2) Divide the spray gun. Press the hook (Fig. 3 "click") slightly downwards. Turn the gun
front part and gun rear part against each other and take them apart.
3) Unscrew the container. Empty any remaining coating material back into the material
tin.
4) Preclean the container and suction tube with a brush. Clean the ventilating bore
(Fig. 9, C).
5) Pour solvent or water into the container. Screw the container back on.
Do not use flammable materials for cleaning purposes.
6) Assemble the gun again (Fig. 3).
7) Turn on the machine and spray the solvent or water into a container or a cloth.
8) Repeat the above procedure until the solvent or water emerging from the nozzle is
clear.
9) Turn off the machine and remove the plug.
10) Screw of the container and empty it. Pull out the suction tube with container seal.
CAUTION!
Never clean seals, diaphragm and nozzle or air holes of the spray gun with metal
objects.
The ventilation hose and diaphragm are only solvent-resistant to a limited
extent. Do not immerse in solvent, only wipe.
11) Unscrew the union nut (Fig. 9, 1) and remove the air cap (2) and nozzle (3). Clean the
air cap, nozzle seal (4) and nozzle with a brush and solvent or water.
12) The unit may only be operated with an integer diaphragm (Fig. 10, 15).
If any
paint has penetrated to the ventilation hose, check and clean the membrane (see
the Maintenance chapter).
WARNING! Never hold the spray gun rear part under water or immerse it
into liquids. Clean the housing only with a moistened cloth.
13) Clean the outside of the spray gun and container with a cloth soaked in solvent or water.
14) Assemble the parts again (see “Assembly”).
Assembly
Attention! Never operate the device if the nozzle seal is either damaged or
missing. If the nozzle seal is either missing or damaged liquids can enter
the device and increase the risk of an electric shock.
1) Push the nozzle seal (fig. 11, 4) over the needle (18); the groove (slot) should point
towards you.
2) Put the nozzle (fig. 11, 3) onto the gun body and find the correct position by turning it.
3) Put the air cap onto the nozzle and tighten it using the union nut.
4) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
5) Insert the suction tube with container seal in the gun body.
i
In order to mount the gun more easily apply lubricating grease (enclosed)
liberally to the O-ring at the gun front part. (Fig. 13, Item 6)
Summary of Contents for W 150
