GB
25
W 540
Problem
Cause
Remedy
Coating
material drips
from the nozzle
•
Nozzle loose
•
Nozzle worn
•
Nozzle seal is missing or worn
•
Coating material assembly at air
cap, nozzle or needle
➞
Tighten
➞
Change
➞
Insert an intact nozzle seal
➞
Clean
Atomisation too
coarse
•
Viscosity of coating material too
high
•
Material volume too large
Material volume adjusting screw
turned too far to the right (+)
•
Nozzle contaminated
•
Air filter heavily soiled
•
Too little pressure build-up in
container
➞
Thin
➞
Turn material volume
adjusting screw to the
left (-)
➞
Clean
➞
Change
➞
Tighten container
Spray jet
pulsates
•
Coating material in container
running out
•
Air filter heavily soiled
•
Nozzle seal is missing or worn
➞
Refill
➞
Change
➞
Insert an intact nozzle seal
Coating
material causes
"paint tears"
•
Too much coating material
applied.
➞
Turn material volume
adjusting screw to the
left (-)
Too much fog of
coating material
(Overspray)
•
Distance to the object too large
•
Too much coating material
applied
➞
Reduce distance
➞
Turn material volume
adjusting screw to the
left (-)
Paint in the
ventilating hose
•
Diaphragm soiled
•
Diaphragm defective
➞
Clean the diaphragm
➞
Replace the diaphragm
18. Technical Data
Technical Data
Max. viscosity
90 DIN-s
Power source
230 V
~
, 50 Hz
Power consumption
280 W
Atomizing output:
65 W
Protection Class:
I
Sound pressure level*
79 dB (A); Uncertainty K = 4 dB
Sound pressure output*
92 dB (A); Uncertainty K = 4 dB
Oscillation level*
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
Weight
1,3 kg
Summary of Contents for W 540
