GB
20
W 550
6. Coating Materials Not Suitable for Use
Wall paints without the red Perfect Spray logo.
Alkali and acidic paints. Flammable materials.
7. Preparation of the Coating Material
The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet
of the manufacturer (
Internet download).
1.
Stir the material up and put the required amount into the paint container.
Thinning recommendation
Sprayed material
Glazes
undiluted
Wood preservatives, mordants, oils, disinfection
agents, plant protective agents
undiluted
Paints containing solvents and water-soluble paints,
primers, vehicle coating paints, thick-film glazes
dilute by 5 - 10%
Wall paints with the red Perfect Spray logo
dilute in accordance with
manufacturer's instructions
2.
If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfils your requirements.
8. Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
Unscrew the container from the spray gun.
•
Aligning suction tube. (Fig. 2)
•
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When working on lying objects: Turn the suction tube forwards. (Fig. 2 A)
Spraying work when working on overhead objects: Turn the suction tube rearwards.
(Fig. 2 B)
Set the container on a sheet of paper, pour in the prepared coating material and screw
•
the container tightly onto the spray gun.
Connect the front part with the rear part of the gun (Fig. 3).
•
Put the machine down only on a level, clean surface. Otherwise the machine could tip
•
over!
Pull the trigger guard. The W 550 has a two-stage trigger guard. In the first stage the
•
turbine is started. If the trigger guard is pressed further, the material is transported.
Adjust the spray setting on the spray gun.
•