25
W 600 Flexio 18V
EN
23. Accessories
The CLICK&PAINT SYSTEM with additional spray attachments and accessories
offers the right tool for each work.
Further information about the WAGNER range of products for renovating is available
under www.wagner-group.com
24. Correction of Malfunctions
Problem
Problem
Cause
Cause
Remedy
Remedy
No coating material
emerges from the
nozzle
•
Device not switched on
(trigger cannot be pulled)
•
Battery flat, faulty or incompatible
•
Nozzle clogged
•
Feed tube clogged
•
Material quantity too small
•
Feed tube loose
•
No pressure build-up in container
•
Ventilating bore (Fig. 14, 1) clogged
•
Press the ON/OFF switch
on the side of the device
•
Charge or replace
•
Clean
•
Clean
•
Increase the quantity of
material
•
Insert
•
Tighten container
•
Clean
Coating material
drips from the
nozzle
•
Nozzle loose
•
Nozzle worn
•
Nozzle seal is missing or worn
•
Coating material assembly at air
cap, nozzle or needle
•
Tighten
•
Change
•
Change
•
Clean
Atomisation too
coarse
•
Coating material too thick
•
Material volume too large
•
Nozzle clogged
•
Air cap assembled incorrectly
•
Air filter heavily soiled
•
Too little pressure build-up in
container
•
Amount of air too low
•
Dilute
•
Reduce the material
volume
•
Clean
•
Snap air cap properly
into place (fig. 19, 2)
•
Change
•
Tighten container
•
Increase air quantity
Spray jet pulsates
•
Coating material in container
running out
•
Air filter heavily soiled
•
Nozzle seal is missing or worn
•
Refill
•
Change
•
Change
Coating material
causes "paint tears"
•
Too much coating material
applied.
•
Reduce the material
volume
Summary of Contents for W 600 FLEXIO 18V
