WAGNER W 660, Manual

GB

28

 W 660

Adjusting the Material Volume (Fig. 8)

Set the material volume by turning the regulator on the trigger guard of the spray gun
-

turn to the left



  lower material volume

+ turn to the right



  higher material volume

Spray Technique

The spray result depends heavily on the smoothness and cleanliness of the surface to 

• 

be sprayed. Therefore the surface should be carefully prepared and kept free of dust.

Cover all surfaces not to be sprayed. 

• 

Cover screw threads or similar parts of the target object.

• 

It is advisable to test the spray gun on cardboard or a similar surface to find the 

• 

correct setting. 

Important:

   Begin spraying outside of the target area and avoid interruptions inside 

the target area.

The spray movement should come from the arm, not just from the wrist. This ensures 

that a uniform distance is maintained between the spray gun and the spray surface 

during the spray operation. Select a distance of 5 - 15 cm, depending on the desired 

spray jet width.

Fig. 9 a:  

CORRECT

 Even distance to the object.

Fig. 9 b:  

INCORRECT 

Uneven distance causes uneven coating.

Move the spray gun evenly cross-wise or up-and-down, depending on the spray 

• 

pattern setting.

An even movement of the spray gun results in an even surface quality.

• 

When coating material builds up on the nozzle and air cap, clean both parts with a 

• 

solvent or water.

Interruption of Work till 4 Hours

Turn the machine off.

• 

Insert the spray gun into the gun holder.

• 

When processing 2-component varnishes, clean the device immediately.

• 

Taking Out of Operation and Cleaning

Proper cleaning is the prerequisite for problem-free operation of the paint application 

device. No warranty claims are accepted in case of improper or no cleaning.

 Turn the machine off. Vent the container in case of longer breaks and after the work 

1) 

has been terminated. This can be done by briefly turning open and then closing the 

container or by pulling the trigger guard and letting the paint into the original paint 

container.

Divide the spray gun. Press the hook (Fig. 5 "click") slightly downwards. Turn the gun 

2) 

front part and gun rear part against each other.

Unscrew the container. Empty any remaining coating material back into the material 

3) 

tin.

Preclean  the  container  and  feed  tube  with  a  brush.  Clean  the  ventilating  bore 

4) 

(Fig. 12, C).

Pour solvent or water into the container. Screw the container back on. 

5) 

Use only solvents with a flashpoint over 21 °C.

Assemble the gun again (Fig. 5).

6) 

Turn on the machine and spray the solvent or water into a container or a cloth.

7) 

Repeat the above procedure until the solvent or water emerging from the nozzle is 

8) 

clear.