WAGNER W 690 Flexio, Operating Instructions Manual

7

W 690 Flexio Extra Spray Kit

AUS

6. Preparation of the workplace (for interior wall paint)

Sockets and plugs must be masked. Risk of an electric shock as a 

consequence of sprayed material entering the socket!  

Mask all the areas and objects that are not to be spray painted, or 

remove them from the work area. No liability is assumed for damage 

due to overspray.

Silicate paint corrodes glass and ceramic surfaces 

upon contact! All such surfaces must therefore be completely covered.

i

Pay attention to the quality of the adhesive tape used. 

Do not use excessively strong adhesive tape on wallpaper and painted 

surfaces, in order to avoid damaging these surfaces when removing the 

tape. Remove adhesive tape slowly and evenly; do not use jerky movements. 

Do not leave adhesive tape on surfaces any longer than necessary, in order 

to minimise the possibility of residues when removing. 

Also observe the adhesive tape manufacturer's instructions.

7. 

Preparation of the Coating Material

• 

Mix the material well in the original container. When using interior wall paint, an 

agitator is recommended.

i

W 690 has been developed for use with all conventional paints in their undiluted 

form. If the surface is smooth and the paint you are using is very thick and 

gel-like, dilute it by 10%. Dilution can be necessary if the atomisation is 

coarse or if the flow rate is too low even at the maximum setting.  

Detailed information about the various materials and the maximum permitted 

dilution can be found on the manufacturers' technical data sheets (e.g. available 

on the Internet). 

i

Spray material that is at least at room temperature provides a better spray 

result. 

8. Start-up

Before connecting to the mains supply, be sure that the supply voltage is identical with 

the value given on the rating plate.  

Put the machine down only on a level, clean surface. Otherwise, the gun may suck in 

dust, etc.

1.   Attach the carrying strap to the unit. (Fig. 2)

2.   Mount the air hose (Fig. 3, A + B). Insert the air hose firmly into the connection of the 

unit and the gun handle.