WAGNER W 690 Flexio, Operating Instructions Manual

11

W 690 Flexio Extra Spray Kit

AUS

container or by pulling the trigger guard and letting the paint into the original paint 

container.

2)  Divide the spray gun. Press the hook (Fig. 5 ) slightly downwards. Turn the gun  front 

part and gun rear part against each other and take them apart.

16.   Cleaning the Wall Extra I-Spray spray 

attachment

1) Unscrew the container. Empty any remaining coating material back into the material tin.

2) Pull out the suction tub with container seal. Clean the ventilating bore (Fig. 17, A).

CAUTION!  

Never clean seals, diaphragm and nozzle or air holes of the spray gun with metal 

objects. 

The ventilation hose and diaphragm are only solvent-resistant to a limited 

extent. Do not immerse in solvent, only wipe.

3)  

The unit may only be operated with an integer diaphragm (Fig. 18, C).

 If any 

paint has penetrated to the ventilation hose, check and clean the membrane (see the 

Maintenance chapter).

3)   Move the air cap (Fig. 19, 1) to the vertical position for easier removal and lift it off.

4)   Unscrew the union nut (fig. 19, 2). Clean the air cap (1) and nozzle (3) with a brush and 

solvent or water.

Attention! Never remove the red nozzle seal from the nozzle. If the nozzle 

seal is either missing or damaged liquids can enter the device and increase 

the risk of an electric shock. 

Assembly

Attention! Never operate the device if the nozzle seal is either damaged or 

missing. If the nozzle seal is either missing or damaged liquids can enter 

the device and increase the risk of an electric shock.

1)   Check the nozzle seal (fig. 20, 4) in the nozzle.

2)   Screw the union nut (Fig. 21, 2) onto the gun and tighten it.

Tighten the union nut (Fig. 21, 2) fully so that no paint is able to penetrate 

the device. 

3)   Engage the air cap (Fig. 22, 1) with the union nut. 

Check if the air cap has properly 

locked into place on both sides. (Fig. 23, 1)

4)   Place the container seal from below on the suction tube and slide it over the collar, 

while turning the container seal slightly. 

5)   Insert the suction tube with container seal in the gun body.

In order to mount the gun more easily apply lubricating grease (enclosed) liberally 

to the O-ring at the gun front part.

(Fig. 28, 3)