Spray gun W 90
15
GB
Measuring the Viscosity
Dip the viscosity test cup (Illus. 1 a) into the spray material. Hold the
test cup up and measure the time (in seconds) until the liquid empties
out. Compare the measured „run-out time“ with the Viscosity Table.
Start-up
1.
Before connecting to the mains supply, please be sure that the
supply voltage is identical with the value given on the rating plate
(on the side of the spray gun).
Caution!
Do not operate the spray gun without spray material in the
container; this can lead to increased wear of the pump!
2.
Dilute the spray material according to the above table (Illus. 3).
3.
Place the container on a sheet of paper and fill it with the prepared
spray material (Illus. 2).
4.
Position the spray gun on the container and turn the container to
the right until the container fits tightly (Illus. 4).
5.
Activate the switch to start up the spray gun. First the spray gun
sucks in spray material, then after a few seconds the material
emerges from the nozzle. To accelerate the intake, turn the fine
adjustment button to maximum (Illus. 5).
Regulating the Spray Amount with the Fine Adjustment
Button
By turning the fine adjustment button you can vary the spray amount
(Illus. 5).
Note:
Regulating with the fine adjustment button influences the spray
pattern depending on the spray material and the degree of dilution.
