44
W 950 Flexio/ W 975 Flexio
W
all pain
t
44
W 950 Flexio/ W 975 Flexio
EN
i
The spray jet can pulsate when very liquid materials are being used.
However, this does not usually have a negative effect on the results.
i
If the work being performed is of a sophisticated nature (e.g. the borders
around plugs) do not pull the trigger through completely. This prevents the
feed pump from being switched on and the only material that is sprayed is
the material that is already in the system. If this starts to run out, briefly pull
the trigger completely in order to refill the system.
i
"Cross spray" when using paint with a
poor covering capacity or if the surface
is highly absorbent (Fig. 8).
i
Interior wall paint in strong colour
shades should be applied at least twice
(allow first paint coat to dry first). This
will ensure good coverage.
17.
Interruption of Work
•
Turn the machine off. (Set the multifunction switch to "OFF")
•
Put the spray lance in the holder.
•
Wet paint surface in paint container with a little water to prevent a skin from forming.
•
Clean nozzle openings after an interruption in operation.
18. Switching off and cleaning the spray lance
Proper cleaning is the prerequisite for problem-free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning.
i
We recommend using hot water for cleaning purposes.
•
Turn the machine off. (Set the multifunction switch to "OFF")
•
Remove the suction hose from the paint container.
•
Set the multifunction switch to "FILL/CLEAN".
