12
OPERATING MANUAL
VERSION 01/2013
ORDER NUMBER DOC 2333538
4
GENERAL SAFETY INSTRUCTIONS
4.1
SAFETY INSTRUCTIONS FOR THE OPERATOR
4.1.1
ELECTRICAL EQUIPMENT
4.1.2
PERSONNEL QUALIFICATIONS
4.1.3
SAFE WORK ENVIRONMENT
Keep this operating manual at hand near the device at all times.
Always follow local regulations concerning occupational safety and accident
prevention.
Electrical devices and equipment
To be provided in accordance with the local safety requirements with regard to the
operating mode and ambient infl uences.
May only be maintained by skilled electricians or under their supervision.
Must be operated in accordance with the safety regulations and electrotechnical
regulations.
Must be repaired immediately in the event of problems.
Must be decommissioned if they pose a hazard.
Must be de-energized before work is commenced on active parts. Inform staff about
planned work. Observe electrical safety regulations.
Ensure that the device is operated and repaired only by trained persons.
Make sure that the fl oor in the area where you are working is electrostatically
conductive in accordance with EN 61340-4-1. (The resistance value may not exceed
100 MOhm).
Ensure that all persons within the working area wear electrostatically conductive
shoes. Footwear must comply with EN 20344. The measured insulation resistance may
not exceed 100 MOhm.
Ensure that during spraying, persons wear electrically conductive gloves. The
grounding takes place via the spray gun handle.
If protective clothing is worn, including gloves, it has to comply with EN 1149-5. The
measured insulation resistance may not exceed 100 MOhm.
Paint mist extraction systems must be fi tted on site according to local regulations.
Ensure that the following components of a safe working environment are available:
– material/air hoses adapted to the working pressure.
– Personal safety equipment (breathing and skin protection).
Ensure that there are no ignition sources such as naked fl ames, sparks, glowing wires
or hot surfaces in the vicinity. Do not smoke.
