Operating manual Piston pump IceBreaker 40-200 ccm (Finishing)
7 Operation
Order number 2333538 | Edition 03/2021
51
Preparation
1. Visual check: personal safety equipment, grounding and all devices ready to use.
2. Relieve the pump's pressure according to Chapter Pressure Relief / Work Interruption
49].
3. Place an empty, grounded collection tank (5) under the return tube (4).
4. Place the suction hose (7) in the grounded tank with flushing agent (6).
5. Adjust the pressure regulator (1) to approx. 0.05 MPa; 0.5 bar; 7.25 psi.
Flushing via the return valve
1. Open return valve (3).
2. Slowly open the ball valve (2).
3. Adjust the air pressure on the pressure regulator (1) so that the pump runs smoothly.
4. Flush the system until clean flushing agent flows into the tank (5).
5. Close ball valve (2).
6. As soon as there is no pressure remaining in the system, close the return valve (3).
Flushing via spray gun
1. In case of AirCoat systems, carry out the basic flushing without atomizing air.
2. Point the spray gun (3), without nozzle, into the tank (5) and pull the trigger.
3. Slowly open the ball valve (2).
4. Rinse until clean flushing agent flows from the spray gun.
5. Close ball valve (2).
6. As soon as there is no pressure remaining in the system, close the spray gun and/or
return valve (8). Secure the spray gun.
External Cleaning
1. Clean the outside of the system.
2. Fully assemble the system.
3. Relieve the pump's pressure according to Chapter Pressure Relief / Work Interruption
49].
4. Dispose of the contents of the tank (5) according to the local regulations.
7.6 FILLING WITH WORKING MATERIAL
After basic flushing, the pump can be filled with working material.
4
Proceed according to Chapter Filling the Empty Pump [
product instead of flushing agent.
