2787-2147 (/0000-00x0)
Provisions
6
Product manual | Version: 1.2.2
Power Supply Pro 2
1
Provisions
This document applies to the following products:
Table 1: Scope of Applicability
Item no.
Item description
2787-2147
WAGO Power Supply Pro 2
2787-2147/0000-0030
WAGO Power Supply Pro 2, with DNV GL Approval
2787-2147/0000-0070
WAGO Power Supply Pro 2, with DNV GL approval and protective coating
Note
Observe the applicable documentation!
This product must only be installed and operated according to the instructions of the com-
plete Instructions for use. Knowledge of the complete Instructions for use is required for
proper use.
1. Carefully read the Product Manual.
2. Before commissioning, follow the instructions in section
8
Table 2: Complete instructions for use
Document Type
Contents
&
Product Manual
Contains all the product-specific information for a product.
&
Instruction leaflet
Is included with each product. Contains initial information on safe handling of
the product.
All the documentation and information is available at:
ü
.
1.1 Intended Use
The 2787 Series WAGO Power Supply Pro 2 provides DC voltage to electrical or elec-
tronic devices, such as industrial control systems or display, communication and measur-
ing devices.
The product is an open system and is designed for installation in a additional enclosure.
• The product is designed for use in dry indoor rooms.
• Operation of the products in industrial area is permitted.
• The product meets the EMC requirements for residential, office and commercial areas
as well as small businesses, if the product used complies with the required emissions
of interference (emission limits).
• Operation of the product in other application areas is only permitted when correspond-
ing approvals and labeling are present.
Improper Use
Improper use of the product is not permitted. Improper use occurs especially in the follow-
ing cases:
• Non-observance of the intended use
• Use without protective measures in an environment in which moisture, salt water, salt
spray mist, dust, corrosive fumes, gases, direct sunlight or ionizing radiation can occur
