2787-2344 (/0000-00x0)
Configuration
42
Product manual | Version: 1.0.1
Power Supply Pro 2
Pos.
Section
Description
5
Footer
The footer indicates the status and interface of the active connec-
tion.
10.3.1 Menu Bar
The menu bar is divided into the “Backstage” and “Device” tabs (see also section
8
10.3.1.1 “Backstage” Tab
The settings options on the “Backstage” tab are described in section
8
10.3.1.2 “Device” Tab
Figure 24: “Device” Tab
Table 53: “Device” Tab
Menu Item
Description
Select
Open the product selection to select a new product
(see also section
8
Disconnect
Connect
Connects/disconnects the connected product to/from
the software
Settings
Opens the “Settings” dialog. The dialog is described in
section
8
.
Snapshot
Creates a snapshot of all parameters and measured
values, which can be stored as a CSV file.
Simulation
Opens the “Simulation” dialog. The dialog is described
in section
8
Update
Performs a firmware update on the product.
You can get the current firmware update and corre-
sponding compatibility information from WAGO Tech-
nical Support.
Recovery
Restores any firmware version.
This may be necessary if a current firmware update
has failed and a connection to the connected product
cannot be established.
10.3.1.2.1 Dialog: Settings
In this dialog, you can modify settings for the product. Two options are available:
• Online: With this option, the
[Save to device]
button writes the settings directly to the
product.
• Offline: With this option, the settings must be saved externally using the
[Export]
but-
ton. If a product is connected to the software later on, you can import these settings
into the software with the
[Import]
button and then write them directly to the product
with the
[Save to device]
button.
The settings can be made in the following sections:
